Showing 1–8 of 35 results
Performing a resistance measurement
The resistance measurement in the Multi Channel oscilloscope software is briefly explained.
Read more
Performing a SureConnect connection test
The connection test function of the Multi Channel oscilloscope software is briefly explained, with explanation how to do a connection test.
Read more
Performing a recorder mode measurement
The recorder mode of the Multi Channel oscilloscope software is briefly explained, with an example of its use during a measurement on sensors and actuators.
Read more
Performing an intermittent fault measurement
Instructions for performing an intermittent fault measurement with TiePie oscilloscope, with explanation and example.
Read more
Performing a smooth running test
A smooth engine running test is performed with a lab scope to check the condition of main input and output signal from an engine management system. The smooth engine running test is performed on engines that run troublesome, misfire or have erratic fault at higher RPM's. Example signals are shown and can be downloaded.
Read more
Performing a power measurement
Engine power measurement (kW and hp) with accelerometer and lab scope, performed while driving a vehicle, without dyno or other test facilities.
Read more
Performing a relative compression test
The relative compression test in Multi Channel oscilloscope software is briefly explained, with instructions on how to perform a relative compression test with just a lab scope and current clamp.
Read more
ABS sensor inductive
With a lab scope an inductive ABS sensor is measured on a wheel that is turned by hand. The signal from the sensor is shown and can be downloaded. To help determining whether an inductive ABS sensor is functioning correctly, different possible deviations from the example signal are mentioned along with possible causes.
Read more