Latest news

Mechanical shock protection for your Handyscope

Rubber protector TP-RP-HS: protect Handyscope series USB oscilloscope against mechanical shocks.

Read more
May 23, 2013

Automotive example: Intermittent fault measurement

New automotive example about measuring intermittent faults.

Read more
May 16, 2013

Automotive examples: EGR valve DC motor and position sensor

Two new automotive examples about measuring a DC motor of a controlled EGR valve and about measuring an EGR valve position sensor. Both articles contain downloadable settings files with measured data.

Read more
April 3, 2013

Automotive example: Engine power measurement

New automotive example about measuring car engine power using just oscillsocope and accelerometer.

Read more
February 11, 2013

Measurement examples available

A new section containing measurement examples is now available. This section contains examples of measurements performed on automotive sensors and automotive actuators.

Read more
June 25, 2012

Article: Kia Carens with mixture problem

A new automotive application article about a Kia Carens with a mixture problem is available. A Kia Carens with 1.6 liter engine keeps generating an oxygen sensor related code that the fuel mixture was too rich. Resetting the error and driving the car would set the error code again. Several components were replaced, even the Electronic Control Module (ECM), but the error kept coming back. Diagnosing using a automotive lab scope revealed the cause of the problem.

Read more
February 1, 2012

Article: Citroën Xantia refuses to start

A new automotive application article about a Citroën Xantia refusing to start is available. A 1999 Citroën Xantia had a new starter motor fitted, after which it would not run anymore. While cranking it would fire briefly and then die. The car’s battery had been disconnected for the starter motor job. A crankshaft sensor code was logged and thus the crankshaft sensor was replaced, regardless of the good signal. Later the ECM was replaced all with no positive results. The question was if the immobilizer could have reset itself by disconnecting the battery. Proper measuring revealed what the real problem was.

Read more
December 12, 2011

Article: Stuttering Ford Fiesta

A new automotive application article about a stuttering Ford Fiesta is available. When trouble shooting intermittent problems, a good automotive oscilloscope is indispensable. A Ford Fiesta with J6B engine was suffering occasional stuttering. The shop it was brought to did not have an oscilloscope, so they could not easily locate the source of the problem. They did replace some components, but the problem remained. Using an automotive diagnostic oscilloscope, the problem was soon found.

Read more
November 30, 2011